This provides the vehicle with the absolute brightest and most noticeable tail light function. The panels will often light up areas that the OEM lighting does not illuminate. Unlike many aftermarket LED panels, our panels are specifically designed to utilize all available lighting area available in the tail light lenses. Ignition must be On to provide sequential flashing.Įach CST kit is uniquely engineered for each application. This allows running illumination and warning flashers when the key is out of the ignition. The exclusive design also allows the tail light panel to perform running light, brake light and emergency flasher functions when the vehicle is not running. This eliminates unnecessary current draw on the battery that can lead to a dead battery over time. When ignition power is Off, the tail light panels do not draw any power from the vehicle. The selection is stored in memory within the onboard controller so every time vehicle is started, the same pattern is used. Selection is performed while panel is powered up so user can observe each pattern until the desired pattern is determined. Each press of the switch steps panel through each of the available patterns. If sequential lighting patterns are desired, then the attached pink wire must be wired to +12 volt ignition power.Ī push button switch on the back or front of the light panel is used to select from any of the pre-programmed sequential patterns. The simple installation requires a quick mounting of the LED lighting panel to the tail light housing or lens, depending on application and plugging in the wired bulb plug(s) into the factory bulb socket(s). Standard Flash Mode: Flashes all LED's in all panels together with the flasher relay or solid light with brake, mimics light bulb operationĭemonstration Mode: Steps through each sequential pattern cyclically, flashes each sequence 6 times before stepping to the next sequence, then repeats Tail Light Operational Functions: Turn Signal Light, Brake Light, Running Light and Emergency Flash (not including demonstration and standard flash modes) Number of Sequential Patterns: 8 > Industry First << For LED lighting to function properly, a Low Current Flasher Module must be installed in place of the traditional turn signal flasher module. The kit is designed to work with OEM tail light housing and lenses as well as aftermarket components. There is no separate sequential lighting control module to mount and wire up. In addition, the kit includes a self-contained microprocessor and circuitry to enable a multitude of sequential lighting patterns. This includes low level running light illumination, brake light illumination, turn signal illumination, emergency flash and back-up lighting where applicable. The kits replace all the functionality of the light bulbs they replace. These kits incorporate high efficiency LED lights that increase tail light brightness, reliability and longevity. Orders leave the same or next business day.The Classic Sequential Tail Light (CST) kits are direct retrofit and replacement for incandescent light bulbs in classic vehicles. Product on this page is in stock at our location and ready to ship. Screaming Chicken is an authorized Digi-Tails dealer. Product includes: Tail light panels only (housing or lens not included) Each light-panel has a protective coating to prevent rusting and corrosion. They meet or exceeds DOT & SAE requirements. Digi-tails are designed and assembled for durability and unsurpassed quality here in the USA. The care in design gives you an easier installation and exceptional appearance. Kits come complete with everything needed to replace your old standard bulbs with high quality LED lighting instructions are included. Digi-tails have been custom engineered to fit the 1979-81 Firebird housing precisely, rather than using a generic light panel. The panels allow your to choose standard function or fully sequential with a flip of a switch, conveniently located on the board. The panels utilize advanced technology by LED's in a fluid and sweeping pattern, rather than merely lighting up blocks of LEDs. Digi-tails panels are the only fully sequential LED kit. The panels replace everything in your tail light housing except the reverse lights (led bulbs can be added to your order). Panels install into your stock tail light housings reusing your stock lens and bezel. Dramatically enhance your tail lights with safer, brighter, and fully sequential LED light-panels with Digi-tails LED tail light panels for 1979-81 Firebirds.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |